Page History

size

The maximum capacity of the SEDA queue (i.e., the number of messages it can hold). The default value in Camel 2.2 or older is 1000. From Camel 2.3 onwards, the size is unbounded by default. Notice: Mind if you use this option, then its the first endpoint being created with the queue name, that determines the size. To make sure all endpoints use same size, then configure the size option on all of them, or the first endpoint being created. From Camel 2.11 onwards, a validation is taken place to ensure if using mixed queue sizes for the same queue name, Camel would detect this and fail creating the endpoint.

concurrentConsumers

1

Number of concurrent threads processing exchanges.

waitForTaskToComplete

IfReplyExpected

Option to specify whether the caller should wait for the async task to complete or not before continuing. The following three options are supported: Always, Never or IfReplyExpected. The first two values are self-explanatory. The last value, IfReplyExpected, will only wait if the message is Request Reply based. The default option is IfReplyExpected. See more information about Async messaging.

timeout

30000

Timeout (in milliseconds) before a SEDA producer will stop waiting for an asynchronous task to complete. See waitForTaskToComplete and Async for more details. In Camel 2.2 you can now disable timeout by using 0 or a negative value.

multipleConsumers

2.2

false

Specifies whether multiple consumers are allowed. If enabled, you can use SEDA for Publish-Subscribe messaging. That is, you can send a message to the SEDA queue and have each consumer receive a copy of the message. When enabled, this option should be specified on every consumer endpoint.

limitConcurrentConsumers

2.3

true

Whether to limit the number of concurrentConsumers to the maximum of 500. By default, an exception will be thrown if a SEDA endpoint is configured with a greater number. You can disable that check by turning this option off.

blockWhenFull

2.9

false

Whether a thread that sends messages to a full SEDA queue will block until the queue's capacity is no longer exhausted. By default, an exception will be thrown stating that the queue is full. By enabling this option, the calling thread will instead block and wait until the message can be accepted.

queueSize

2.9

Component only: The maximum default size (capacity of the number of messages it can hold) of the SEDA queue. This option is used if size is not in use.

pollTimeout

2.9.3

1000

Consumer only – The timeout used when polling. When a timeout occurs, the consumer can check whether it is allowed to continue running. Setting a lower value allows the consumer to react more quickly upon shutdown.

purgeWhenStopping

2.11.1

false

Whether to purge the task queue when stopping the consumer/route. This allows to stop faster, as any pending messages on the queue is discarded.

queue

2.12.0

null

Define the queue instance which will be used by seda endpoint

queueFactory

2.12.0

null

Define the QueueFactory which could create the queue for the seda endpoint

failIfNoConsumers

2.12.0

false

Whether the producer should fail by throwing an exception, when sending to a SEDA queue with no active consumers.

Only one of the options discardIfNoConsumers and failIfNoConsumers can be enabled at the same time.

Whether the producer should discard the message (do not add the message to the queue), when sending to a SEDA queue with no active consumers.

Only one of the options discardIfNoConsumers and failIfNoConsumers can be enabled at the same time.