THIS IS A TEST INSTANCE. ALL YOUR CHANGES WILL BE LOST!!!!
...
- Check the configuration of your firewalls. UPnP discovery is based on multicast messages over UDP that usually are not filtered by firewalls, on the contrary the XML description of devices is retrieved using HTTP protocol; usually bound to non standard ports which might be blocked. Check whether firewall is active on your host or on the host of the device you want discover.
- * Install a loopback interface if needed. The base driver by default is configured for not using the localhost as loopback interface. If you want to run and test UPnP devices on a machine disconnected by any network, you should install and activate a loopback interface. Pay attention to disable the loopback interface when you are connected to a network again, otherwise both interfaces will be used to expose the UPnP services registered with the framework.
Introduction | Base Driver Overview
...
| Wiki Markup |
|---|
\[1\] The actual version of the bundles may be different |