...
The escaped single quotes around the
remote-locators
property are because of the comma.If these commands are being tested on the same host, then in addition to the locator ports, the following ports will also need to be unique and configured on the command line:
jmx-manager-http-port
(configured like--J=-Dgemfire.jmx-manager-http-port=8081
)jmx-manager-port
(configured like--J=-Dgemfire.jmx-manager-port=1091
)
The figure below shows the locators connected to each other across the WAN network.
...
Code Block |
---|
connect --locator=ln_host[10331] create gateway-sender --id=ny --remote-distributed-system-id=1 --parallel=true create gateway-sender --id=tk --remote-distributed-system-id=3 --parallel=true create gateway-receiver alter region --name=data --gateway-sender-id=ny,tk |
TK Site
Code Block |
---|
connect --locator=tk_host[10331] create gateway-sender --id=ny --remote-distributed-system-id=1 --parallel=true create gateway-sender --id=ln --remote-distributed-system-id=2 --parallel=true create gateway-receiver alter region --name=data --gateway-sender-id=ny,ln |
...
Supported Topologies
The GemFire Multi-site Architecture supports several different topologies. See the GemFire documentation for additional details regarding supported and unsupported configurations.
...