Page History

...

Authors: Alberto Gomez (alberto.gomez@est.tech)

Status: Draft | Discussion | Active | Dropped | Superseded

Superseded by: N/A

...

The command will also assume that during the replication of the data there will be no clients connected to destination site until the copy has finished. If, for any reason, the replication fails or does not finish, the command will have to be run again. The command should provide information about the result of the execution.

Events replicated by this command, must not be notified to the clients in the remote site and should not be sent to other sites from the remote site.

Changes and Additions to Public Interfaces

...

Answers to questions you’ve commonly been asked after requesting comments for this proposal.

Errata

...

• Instead of putting events in the sender's queue, the command will put events directly in batches and pass them to the gateway sender to be sent to the remote site.
• The name of the command has been changed to: wan-copy region