Status
Current state: Discuss
Discussion thread: here
JIRA:
Please keep the discussion on the mailing list rather than commenting on the wiki (wiki discussions get unwieldy fast).
Motivation
Currently, the initial socket connection timeout is depending on Linux kernel setting tcp_syn_retries. The timeout value is 2 ^ (tcp_sync_retries + 1) - 1 seconds. For the reasons below, we want to control the client-side socket timeout directly using configuration files.
- The default value of Linux tcp_syn_retries is 6. It means the default timeout value is 127 seconds and too long in some scenarios. For example, when the user specifies a list of N bootstrap-servers and no connection has been built between the client and the servers, the least loaded node provider will poll all the server nodes specified by the user. If M servers in the bootstrap-servers list are offline, the client may take (127 * M) seconds to connect to the cluster. In the worst case when M = N - 1, the wait time can be several minutes.
- Though we may set the default value of tcp_syn_retries smaller, we will then change the system level network behaviors, which might cause other issues.
- Applications depending on KafkaAdminClient may want to robustly know and control the initial socket connect timeout, which can help throw corresponding exceptions in their layer.
Public Interfaces
We propose a new common client config
connections.setup.timeout.ms: The configuration controls the maximum amount of time the client will wait for the initial socket connection to be built. If the connection is not built before the timeout elapses the network client will close the socket channel. The default value will be 10 seconds.
Proposed Changes
I'm proposing to do a lazy socket connection time out. That is, we only check if we need to timeout a socket when we consider the corresponding node as a candidate in the node provider.
NetworkClient
public Node leastLoadedNode(long now)
- This function iterates over all cached nodes and provides a node for the AdminClient to send the request. We can add our timeout checking logic inside the iteration, which won't downgrade the performance.
Currently, when no active connection exists, the provider will provide the node with the largest index in the node list by qualifying nodes using canConnect(), which is checking if the connection state is DISCONNECTED and if the reconnect backoff is meet. This is not appropriate because we need to poll every node (probably round-robin). Consider the case when we have multiple DISCONNECTED nodes and the time interval between the two provide() invokes is greater than reconnect.backoff.ms. The Provider can provide the same nodes all the time. Thus, the provider should provide the nodes with the least failed attempts among all nodes passing the canConnect() check.
Compatibility, Deprecation, and Migration Plan
No impact
Rejected Alternatives
- Use request.timeout.ms to time out the socket connection at the client level instead of the network client level
- request.timeout.ms is at the client/request level. We need one in the NetworkClient level to control the connection states.
- The socket connection timeout should be relatively shorter than the request timeout. It's good to have a separate config.
- Add a new connection state TIMEOUT besides DISCONNECTED, CONNECTING, CHECKING_API_VERSIONS, READY, and AUTHENTICATION_FAILED.
- We don't necessarily need to differentiate the timeout and disconnected states.